Common fault solutions for filling peristaltic pumps

2021-07-08

After the filling Peristaltic Pump encounters problems in the normal production and operation process, it can be quickly eliminated, solve the problems, and avoid affecting the normal operation, which will have important economic significance. According to some problems frequently encountered in daily use of the filling Peristaltic pump, some common problems and corresponding solutions are given.

When filling large specifications, the feed tank is insufficient to make the liquid level unstable. You can increase the amount of feed or re-close the ball valve above the filling head to reset the filling time (lengthen the filling time) to slow down the filling Install speed to solve.
2. After adjusting the digital dial code or unit, the time does not change:
At this time, turn off the power and reconnect the power.
3. The liquid level is stable and the filling volume is not accurate:
There is debris blocking the filling channel, mainly at the entrance of the trough or in the filling mouth, check and clean it up.
4. There is a drip after closing:
1. The orifice of the filling nozzle is damaged, the filling nozzle can be taken out to repair the orifice.
2. The ball valve in the filling head is damaged, and the ball valve needs to be replaced.
5. No filling after touching the filling switch, the time relay digital indicator LED does not flash:
The injection switch is damaged or the base of the time relay is loose, replace the injection switch of the same model or press the base of the time relay tightly.

Previous: Application of Mini Peristaltic Pump in Automatic Washing Machine

Next: Talking about the product characteristics of micro diaphragm pumps